Zippy Technology MRM-6650P Manuel télécharger pdf (Page 10)

3) Once you hear the buzzer sound or see the warning LED in RED, please check,

a) If the loading is under the minimum or over the maximum load of each

channel.

b) If the power source is well connected and supplied.

Shall the above condition is happened, please disconnect the power source and

wait for 2-3 minutes to release the protection status; then test it again.

c) If buzzer keeps alarming or LED indicates the power module failure, please

locate which power module is defective. Perform hot-swap procedures (ref. to

Sec. 1.8 Hot-Swap Procedures). Return the defective power module back to

your vendor for RMA procedure.

d) If you can not fix the problem, please contact your vendor for supporting.

Note:

* The description stated herein is subject to change without prior notice.

* All brand names and trademarks are the property of their respective owners.

1 2 3 4 5 6 7 8 9 10

Pas de commentaire

Zippy Technology MRM-6650P Manuel Page 10