Zippy Technology R2W-6500P Spécifications télécharger pdf (Page 12)

If everything works out fine, then turn off (remote off) the power system. Now

put back the cover of the case and tighten with the screws that you have retained

earlier. Now you have completed the installation of the R2W redundant power

supply system.

1.9 HOT-SWAP PROCEDURES

Please refer to the following when either power module or the fan found

defective.

A) Locate the defective power module by examining the individual LED (if LED

without light, it indicates the power module is defective).

***WARNING:

Please perform the above step carefully otherwise it may cause shut down the

whole system.

***WARNING:

Please do not remove the defective power module until you have worn gloves to

keep from be burned. This is due to the cover of the power module is used as heat

sink for cooling, usually the temperature is around 50 ~ 60 degree Celsius under

full load condition.

B) Loosen the bracket screws of the power module

C) Remove the defective power module by pulling out method

***WARNING:

Please put aside the power module await for cooling down. Keep from other

people tough it until it is cool.

1 2 ... 7 8 9 10 11 12 13 14 15

Pas de commentaire

Zippy Technology R2W-6500P Spécifications Page 12