D) Replace a new Good power module, insert the power module into the power
system to the end.
E) Check the LED of the power module light Green.
F) Check the LED indicating the total power system status. It should be from
twinkle to Green.
G) Tighten the screws of the power module to fix it.
H) If you want to test this new power module in simulating defective situation.
Please refer to the Section 1.8 Installation & Testing Section.
Remarks: If the DC fan of the power module fail, you have to replace the power
module. Please follow with the Hot-Swap procedures of the power module.
1.10 PINOUTS AND FUNCTION OF THE CONNECTORS
*** Please be aware of the polarity***
THE POWER SIGNAL CONNECTOR OF TOTAL POWER
PIN# COLOR CONDITION
1 RED POWER FAIL
2 BLACK GND
3 GREEN POWER OK
THE BUZZER RESET SWITCH CONNECTOR
PIN# COLOR LEVEL
1 YELLOW +5VSB(PULL HIGH)
2 BLACK GND
THE SIGNAL CONNECTOR OF POWER RESET
PIN# COLOR VOLTAGE
1 RED TTL SIGNAL
(OPEN COLLECTOR)
2 BLACK GND
12
Commentaires sur ces manuels